3D Printing

HSGR 3D printers are controlled via octopi.

1. TAZ 4: http://octopi.hsgr.awmn/TAZ4
2. AO100: http://octopi.hsgr.awmn/A100/
3. Delta: WiP
4. CnC: WiP

Username: hsgr Password: hsgr3d

Some ground rules

1. Important: Make sure that the printer bed is free from objects before printing.
2. Keep uploaded files tidy by using folders.
3. Do not stop prints of other users.
4. Replace printer bed tape when it is damaged.

Printing

1. Generate GCode using Slic3r or Cura or PrusaSlicer and the appropriate printer profile.
   1. In order to generate GCode for TAZ4, it is necessary to use these configuration files due to update with E3D Hot-end [1], [2]. The default extrusion nozzle: 0.4mm. Also the firmware was updated to Marlin 1.1.8.
   2. In order to generate GCode for anadelta, it is necessary to use these configuration files. The default extrusion nozzle: 0.4mm. Also the firmware was updated to Marlin 1.1.8.
   3. In order to generate GCode for AO100, it is necessary to use these configuration files. Also the AO100 was updated with E3D v6 hot-end and the in the extruder added a latch part, yellow part in below picture.

The estimated time isn't always accurate!

AO100 with E3D-v6

1. Connect to the printer using the octopi link at the top of the page (Username: hsgr - Password: hsgr3d
2. Turn on the printer
3. Click 'Connect' to connect to the printer
4. Upload your file to the Files section in the bottom left (make a folder if you don't have one already!) and click it to load it
5. Make sure you have the correct fillament
6. Apply the appropriate adhesive for the material you are printing with to the bed
7. Set temperatures if not set by GCode in the Temperatures tab. You can use the presets by clicking the dropdown arrow.
8. Wait for the printer to get to right temperature.
9. Print !!!
10. Turn off the printer